Label a whole spice rack consistently. At 1.5 inches (40 mm) the label fits the lid of most standard spice jars — type the name, pick a font, print 35 to a sheet.
At 40 mm space is tight: one line in readable type is the realistic maximum, and two lines only work for short words. That suits spices well — "paprika", "cumin", "oregano" are short. The real gain is consistency: a spice rack where every jar carries the same typeface and the same label size is far faster to scan than one with assorted stickers. Thirty-five fit on an A4 sheet, so a single run labels an entire rack.
You can print on plain paper and cut along the marks, or use a pre-cut sheet made for this format:
| Avery Zweckform 5080 | Ø 40 mm round, white, removable. 240 labels on 10 A4 sheets — removable matters here, because spice jars get refilled. |
|---|---|
| Plain paper | Print and cut out. At 40 mm a clean cut matters more, because small irregularities are proportionally more visible. |
At 40 mm you get 35 labels in a 5 × 7 grid per A4 sheet — that is a lot of cuts. Print a test page and check the diameter with a ruler before cutting a full sheet.
Print-to-the-edge round labels for jar lids, 120 per pack. Glossy face, permanent adhesive, laser and inkjet.
Pint jars with lids and bands. The 2" lid matches the round label preset in this editor.
TripleTrack rail and a cut-line wire that shows exactly where the blade lands. The single best upgrade over scissors for printed label sheets.
* As an Amazon Associate we earn from qualifying purchases.